Products

KRE Timing Cover

1969 - 1979

PRW water pumps are manufactured from die casting 108 aluminum alloy. Die casting process with a steel mold eliminates casting porosity to a minimum. Every pump is installed with a heavy duty bearing system combined with a 3/4' integral ball bearing and a 3/4' roller bearing to withstand higher torsion loads at high RPM and also reduce horizontal movement to extend life and minimize the shaft vibration from water flow turbulence. The heavy duty mechanical water seal is for long life operation. Cast iron impellers with curved vanes are machined from CNC centers for accuracy and durability with maximum flow rate and greater pressure. Each pump is put under an endurance test in shop for four hours to ensure the best quality and peak performance condition.

Milodon's High Flow Aluminum Water pump features new castings, large diameter shafts, heavy-duty bearings, and are direct factory replacements with OEM hose connections and bosses. The high-volume pumps have a balanced distribution design (equal flow to both sides of the engine block), and a high efficiency impeller that increases coolant flow up to 30 percent over stock. These features increase coolant pressure in the block to prevent hot spots and air pockets, and improve coolant flow in the radiator. A high-flow thermostat is recommended when using a high-volume pump.